Mag drill
Annular cutter sharpening
Annular cutters do the heavy lifting on mag drills, and a worn cutter slows every hole down while putting extra strain on the machine. We sharpen them back to a precise, consistent edge, so you're into clean, accurate holes again without the cost of replacing the cutter outright.
- Cutting edges returned to a consistent profile
- Custom angles by special request, just ask
- Suits Bunbury and South West shops running mag drills day to day
Get In Touch
TCT & HSS
Saw blade sharpening
A dull blade costs more than it saves: rougher cuts, more force through the material, more heat on the motor. We resharpen tungsten carbide tipped and high-speed steel blades on the Loroch JLM, restoring a clean, true cutting edge so the blade cuts like it did new. We sharpen for fabrication shops cutting steel and aluminium, and forestry and timber operations right across the South West.
- Tooth geometry restored
- Deburred and cleaned
- Panel, docking and circular blades
Get In Touch
Forestry
Chipper blade sharpening
A blunt chipper blade forces the machine to work harder for a worse result: more fuel or power burnt, more strain on the engine, a rougher chip. We sharpen chipper blades to restore an even, efficient cutting edge, so forestry and timber operations across the South West get the most out of every pass.
- Even edge restored across the full blade
- Set up for forestry and timber operations
- Batches welcome, tell us how many
Get In Touch
Custom angles
Drill bit sharpening
Rather than replacing bits the moment they dull, sharpening brings back the original cutting edge for a fraction of what new ones cost. We sharpen for fabrication shops running through them in volume, and for individual tradespeople and DIY customers with a handful to bring back.
- Original cutting geometry restored
- Custom angles by special request
- Volume work and one-offs both fine
Get In Touch
Clean seats
Countersink sharpening
Countersink bits take a beating over time, and a worn one leaves a rough, uneven seat that shows in the finished job. We sharpen them back to a clean, precise cutting edge for consistent countersinks every time. Handy alongside drill bit sharpening for fabrication, engineering and joinery work.
- Clean, even seats again
- Pairs well with a batch of drill bits
- Fabrication, engineering and joinery work
Get In Touch